Epoxy & polyaspartic garage floors in Medina

Gravel drives, grit, and what it does to a floor

Anywhere the driveway isn't paved, the garage floor becomes the collection point:

• Tires carry stone in every single trip. Small gravel drops off in the same places, then gets ground into the slab as the car rolls over it. On bare concrete that's slow abrasion; the surface goes chalky and dusty years before it should.
• Abrasion resistance matters more than gloss here. Polyaspartic is significantly harder-wearing than epoxy against grit, which is the single most relevant property on a gravel-drive property. It's also why we won't spec an epoxy top coat and call it a day.
• Dust is the real complaint. Untreated concrete sheds fine powder constantly, and gravel accelerates it — that grey film on everything stored in the garage is the floor breaking down. Sealing it stops the shedding entirely.
• Sweeping actually works on a sealed floor. Grit sits on top instead of embedding in the pores, so a broom clears it. On bare concrete the same grit works its way in and stays.
• Farm and outbuilding floors too. Plenty of Medina properties have a workshop or barn slab that would benefit more than the house garage does. Same system, quoted the same way by square footage.

One-day garage floor coatings for Medina homes

Every floor we install in Medina is built the same proven way — and finished in a single visit:

• Diamond-grind & repair — we profile the concrete, fill cracks with structural polyurea, and degrease oil spots so the coating bonds permanently.
• Pigmented base + full flake — a tinted base coat, then a full broadcast of vinyl chips in your chosen blend for a deep, even, showroom texture.
• Polyaspartic clear top — a UV-stable, hot-tire-proof top coat. Walk on it the next day, drive on it 24 hours after the top coat.

The finished floor is roughly 50 mil thick — slip-resistant, chemical-resistant, and easy to keep clean with a mop. It's backed by our 3-year workmanship warranty and built to last 15–20+ years.

Why Medina homeowners choose Level Coating

• Abrasion-resistant finish built for grit off a gravel drive
• No more concrete dust settling on everything you store
• Workshops and outbuildings as well as house garages
• One day, start to finish, and the dust leaves with us
• 3-year workmanship warranty, in writing

What a Medina garage floor costs

Our rate is $6 per square foot for the full one-day flake system:

• Two-car (~400–500 sq ft) — about $2,000–$3,000.
• Three-car (~600 sq ft) — around $3,600.
• Workshop or outbuilding (~700–900 sq ft) — roughly $4,200–$5,400.

Medina is inside our normal range from North Royalton and there's no travel surcharge. Older, badly dusted slabs need more grinding, which we'll show you before quoting.

Neighborhoods we serve in Medina

We install across Medina and the surrounding streets, including Public Square · North Court Street · Lafayette Road · Weymouth Road · Reagan Parkway and beyond. If you're nearby and don't see your area, just ask.

Medina garage floor questions

We have a gravel drive. Will stones scratch the new floor?

They'll scuff bare concrete far faster than they'll mark a polyaspartic finish — abrasion resistance is exactly where this system is strongest, and it's why we use it as the top coat rather than more epoxy. The practical difference you'll notice is sweeping: grit sits on the surface and comes off with a broom, instead of grinding itself into the pores the way it does now.

My garage floor makes dust constantly. Is that normal?

It's normal for untreated concrete and it's the floor slowly wearing away, accelerated by any grit that gets tracked in. That grey film on your tools and boxes is the slab. Sealing the surface stops it completely, and it's the change most people notice first — before they notice the colour.

Can you do a barn or workshop floor, not just the garage?

Yes, and on rural properties it's often the better investment. Same one-day system, priced by square footage. Larger spaces occasionally need splitting across two visits, and we'll tell you that upfront rather than halfway through the day.

Worth reading

If grit and dust are the problem: which blends hide dust best · how abrasion and salt wear a floor.